Instruments and controls/Multi function display
4. The selected item will be shown.
– Pull the “
/SET” switch toward you
to set the selected item.
– If you want to select the other item,
operate the “
” switch to go back to
step 3.
5. Select numbers by operating the “ ”
or “
” switch. Then pull the “ /SET”
switch toward you.
6. After entering the date by repeating
step 5, you can enter the name.
7. Select characters by operating the
“
” or “ ” switch. Then pull the “ /
SET” switch toward you.
– You can select characters of the
English alphabet (upper case charac-
ters and lower case characters are
available), eleven symbols or blank
spaces.
– The word being edited will be
displayed with an underline.
3-52
To Next Page
