EasyManua.ls Logo

Subaru Outback 2006 - Activating and Deactivating the Alarm System; Alarm System; If You Have Accidentally Triggered the Alarm System; System Alarm Operation

Subaru Outback 2006
438 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (105,1)
Model "A2440BE-A" EDITED: 2006/ 12/ 6
Alarm system
S02AF
The alarm system helps to protect your
vehicle and valuables from theft. The horn
sounds and the turn signal lights flash if
someone attempts to break into your
vehicle.
The system can be armed and disarmed
with the remote transmitter.
The system does not operate when the
key is inserted into the ignition switch.
Your vehicles alarm system has been set
for activation at the time of shipment from
the factory. You can set the system for
deactivation yourself or have it done by
your SUBARU dealer.
& System alarm operation
S02AF01
The alarm system will give the following
alarms when triggered:
. The vehicles horn will sound and the
turn signal lights will flash for 30 seconds.
. If any door (or the rear gate/trunk lid)
remains open after the 30-second period,
the horn will continue to sound for a
maximum of 3 minutes. If the door (or
the rear gate/trunk lid) is closed while the
horn is soundin g, the h orn will stop
sounding with a delay of up to 30 seconds.
The alarm is triggered by:
. Opening a door, the rear gate or trunk
lid
. Physical impact to the vehicle, such as
forced entry (only vehicles with shock
sensors (dealer option))
& Activating and deactivating
the alarm system
S02AF02
To change the setting of your vehicles
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system (see
s02af05Di-
sarming the system in this section).
2. Sit in the drivers seat and shut all
doors (and the rear gate if your vehicle is a
Station wagon).
3. Turn the ignition switch to the ON
position.
4. Hold down the UNLOCK side of the
drivers power door locking switch, open
the drivers door within the following 1
second, and wait 10 seconds without
releasing the switch. The setting will then
be changed as follows:
If the system was previously activated:
For
2.5-liter non-turbo models, the od-
ometer/trip meter screen displays AL oF,
and for turbo
models and 3.0-liter models,
the multi-information display shows Se-
curity alarm: OFF and the horn sounds
twice, indicating that the system is now
deactivated.
If the system was previously deacti-
vated:
For
2.5-liter non-turbo models, the od-
ometer/trip meter screen displays AL on,
and for turbo
models and 3.0-liter models,
the multi-information display shows Se-
curity alarm: ON and the horn sounds
once, indicating that the system is now
deactivated.
NOTE
You may have the above setting
change done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
S02AF03
! To stop the alarm
S02AF0301
Do any of the following operations:
. Insert the key in the door lock of the
drivers door and turn it to the unlock
position.
. Press any button on the remote trans-
mitter.
. Turn the ignition switch to the ON
position.
Keys and doors 2-15
CONTINUED
2

Table of Contents

Related product manuals