Subaru Outback 2006 User Manual

Black plate (108,1)
北米Model "A2440BE-A" EDITED: 2006/ 12/ 6
2-18 Keys and doors
“ON” position with a registered key.
Insert the key in the door lock of the
driver’s door and turn it to the unlock
position.
& Valet mode
S02AF06
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate (Station wagon) and panic
activation.
To enter the valet mode, change t he
setting of your vehicle’s alarm system for
deactivation mode. (Refer to “
s02af02Activat-
ing and deactivating the alarm system” in
this section.) The security indicator light
will continue to flash once every three
seconds indicating that the system is in
the valet mode.
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. (Refer to “
s02af02Activating and deac-
tivating the alarm system” in this section.)
& Passive arming
S02AF07
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DOORS MUST BE
MANUALLY LOCKED.
! To enter the passive mode
S02AF0701
If you wish to program the passive arming
mode, have it done by your SUBARU
dealer.
! Arming the system
S02AF0702
CAUTION
In passive mode, the system will
automatically activate the alarm but
WILL NOT automatically lock the
doors. In order to lock the doors
you must either lock them as in-
dicated in step 4 below or with the
key once they have been closed.
Failure to lock the doors manually
will result in a higher security risk.
1. Turn the ignition switch to the “ON”
position.
1) LOCK
2) ON
2. Turn the ignition switch from “ON” to
“LOCK” position and remove the key from
the ignition switch.
3. Open the doors and get out of the
vehicle.

Subaru Outback 2006 Specifications

General

Brand	Subaru
Model	Outback 2006
Category	Automobile
Language	English