EasyManuals Logo

Subaru Outback 2006 User Manual

Subaru Outback 2006
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #235 background imageLoading...
Page #235 background image
Black plate (243,1)
Model "A2440BE-A" EDITED: 2006/ 12/ 6
2. Press and hold the two outside
HomeLink® buttons until the indicator light
begins to flash (after 20 seconds). Re-
lease both buttons.
NOTE
If any of the HomeLink® buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all the three buttons.
3. Hold the end of the garage doo r
openers hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
the HomeLink® buttons on the drivers
sun visor, keeping the indicator light in
view.
4. Using both hands, simultaneously
push the hand-held transmitter button
and the desired HomeLink® button. DO
NOT release the buttons until step 5 has
been completed.
5. Hold down both bu ttons until the
HomeLink® indicator light flashes, first
slowly then rapidly. When the indicator
light flashes rapidly, both buttons may be
released. (The rapidly flashing light indi-
cates successful programming of the new
frequency signal.)
6. Press and hold the programmed but-
ton and check the HomeLink® indicator
light. If the indicator light stays on con-
tinuously, your garage door should acti-
vate and the programming is completed.
If the indicator light flashes rapidly for two
seconds and then stays on continuously,
your garage door opener may be pro-
tected by a rolling code feature. In this
case you need to perform the additional
steps for Programming rolling-code-pro-
tected garage door openers in the U.S.A.
described in the following.
NOTE
Rolling-code-protected garage door
openers are manufactured after 1996.
See the instruction manual o f your
garage opener for confirmation.
7. Reconnect the motor of your garage
door opener to the outlet.
8. Te st your garage door op ener by
pressing the programmed H omeLink®
button.
& Programming rolling-code-
protected garage door open-
ers in the U.S.A.
S06AO02
If your garage door opener has a rolling
code feature, program the HomeLink®
Wireless Control System for it by following
steps 1 through 5 in the "Programming
garage door openers in the U.S.A." sec-
tion above and then continuing with the
following steps.
NOTE
The assistance of a second person
Interior equipment 6-19
CONTINUED
6

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Subaru Outback 2006 and is the answer not in the manual?

Subaru Outback 2006 Specifications

General IconGeneral
BrandSubaru
ModelOutback 2006
CategoryAutomobile
LanguageEnglish

Related product manuals