Black plate (101,1)
北米Model "A2440BE-A" EDITED: 2006/ 12/ 6
cing the battery.
.
Be careful not to damage the
printed circuit board in the trans-
mitter when replacing the battery.
.
Be careful not to allow children to
touch the battery and any re-
moved parts; chil dren could
swallow them.
If the transmitter fails to operate when
used within the standard distance, this
may indicate a weak battery. Replace the
battery as soon as possible.
The battery
can be replaced by your authorized
SUBARU dealer. If you replace the battery
by yourself, use utmost care that no dust,
oil or water enters the transmitter.
To replace the battery:
1. Remove the screw on the transmitter
case.
2. Open the transmitter case using a flat-
head screwdriver.
3. Remove the old battery from the
holder.
1) Negative (−) side facing up
4. Replace with a new battery (Type
CR2025 or equivalent) making sure to
install the new battery with the negative
(−) side facing up.
5. Refit the removed half of the transmit-
ter case.
6.
Reinstall the screw on the transmitter
case.
After the battery is replaced, the trans-
mitter must be synchronized with the
keyless entry system’s control unit.
Press either the “
” or “ ” button
six
times
to synchronize the unit.
& Replacing lost transmitters
S02AE09
If you lose a t ransmitter or want to
purchase additional transmitters (up to
Keys and doors 2-11
– CONTINUED –
2
To Next Page
Loading...
Need help?
General
