Subaru Outback 2006 - Automatic Transmission - 5-Speed; Shift Lock Release

Black plate (269,1)
北米Model "A2440BE-A" EDITED: 2006/ 12/ 6
and from there to the manual gate.
In this mode, the transmission shifts up at
higher vehicle speeds and shifts down
more responsively than in normal mode.
& Shift lock release
S07AG06
If the selector lever does not move from
the “P” position with the brake pedal
depressed and the ignition switch in the
“ON” position, perform the following steps:
To override the shift lock:
1. Set the parking brake and stop the
engine.
2. Take out the screwdriver from the tool
bucket.
3. Remove the cover by prying on the
edge with a flat-head screwdriver.
4. Insert the screwdriver into the hole.
5. Push down on the screwdriver and
move the selector lever from the “P” to the
“N” position.
6. Remove the screwdriver from the hole.
Depress the brake pedal and start the
engine.
Take your vehicle to the nearest SUBARU
dealer immediately to have the system
repaired.
Automatic transmission – 5-
speed
S07AH
The automatic transmission is electroni-
cally controlled and provides 5 forward
speeds and 1 reverse speed. Also, it has a
manual mode.
For turbo
and 3.0-liter models, it also has
an SI-DRIVE mode.
For
2.5-liter non-turbo models, it also has
a SPORT mode.
WARNING
Do not shift from the “P” or “N”
position into the “D” or “R” position
while depressing the accelerator
pedal. This may cause the vehicle
to jump forward or backward.
CAUTION
. Shift into the “P” or “R” position
only after the vehicle is comple-
tely stopped. Shifting while the
vehicle is moving may cause
damage to the transmission.
. Do not race the engine for more
than five seconds in any position
except the “N” or “P” position
when the brake is set or when
Starting and operating 7-23
– CONTINUED –
7