Sumitomo Cyclo Drive 6000 - 5.3 Checks before starting installation; 5.5 Check list for ATEX approved gears before commissioning

Drive 6000 Operating Manual
26
Manual D6000_DEU_ENG_08_2019_991376
- Note: Attention, oil-lubricated gearboxes are delivered without oil and must be lled before commissioning.
- Data on the model plate must agree with the existing documentation such as drawings, parts lists, etc.
- The power data of any existing motor must match that of the mains power supply.
- The drive must not be damaged in any way.
- The lubricants provided must be suitable and if necessary prepared for the environmental conditions.
- For gearboxes in long-term storage, the oil must be drained and relled, and the plug replaced with the air
breather; see 3.2.2.1 .
- In the event of long-term storage for a period of more than two years, all radial shaft sealing rings must be
properly replaced before commissioning.
5.3 Checks before starting installation
Ex
Ex
5.4 Preparatory tasks
The anti-corrosive agent (Valvoline Tectyl 846/K19) used for transportation and storage on the shaft-ends or
hollow shafts and on the central seats must be removed before start up. The corrosion protection can be remo-
ved with an alkaline cleaner. Never use mechanical aids (abrasives etc.). The alkaline solvent must not come into
contact with gaskets.
When using lubricants, solvents and corrosion protection products, the protection guidelines for people and the
environment as set out in the corresponding DIN 52 900 safety data sheets must be heeded.
You must check whether the following data on the gear model plate agrees with the permissible explosive
area on site:
- Equipment group
- Ex category
- Ex zone
- Temperature class
- Maximum surface temperature
Make sure that when tting the gearbox there is no explosive atmosphere, oils, acids, gases, vapours or radiation.
Check whether the ambient temperature is within the range of application in accordance with Section 5.7
Ensure that there is enough ventilation to the gear and there is no external heat source (e. g. from couplings).
The cooling air must not exceed a temperature of 40 °C.
Check that the conguration matches the conguration specied on the gear's model plate.
Please note: The design may only be changed after prior consultation with SCG, otherwise the ATEX approval will
lapse.
Please check that all drive parts to be installed are ATEX approved.
With gears with adapters, make sure that the data given on the gear's model plate is not exceeded
With mains operated motors:
Check that the data given on the gear and motor model plates matches the environmental conditions of the
installation location.
5.5 Check list for ATEX approved gears before commissioning
ATEX ID
ATEX classication