Sumitomo Cyclo Drive 6000 - EC Machinery Directive; Notes on Proper Disposal

Drive 6000 Operating Manual
40
Manual D6000_DEU_ENG_08_2019_991376
Reducers
Reducers are considered as “machinery components” and are not subject of the EC machinery
directive 2006/42/EG.
The start of operation within the ambit of the EC machinery directive is forbidden, as long as
it is not conrmed, that the machine, where the reducer is built in, complies with this directive.
From 2010 no manufacturers declaration, EC conformity declaration and declaration of incorporation
will be issued.
Gearmotors
For gearmotors a conformity declaration according low voltage directive will be issued.
11. EC machinery directive
machine directive
2006/42/EG
low voltage directive
2014/35/EG
EMV 2014/30/EU ATEX2014/34/EU
reducer
CE mark no no no yes
declaration of conformity no no no yes
declaration of incorporation no no no no
gearmotor
CE mark no yes (motor) no yes (reducer)
declaration of conformity no yes (motor) no yes (reducer)
declaration of incorporation no no no no
inverter
CE mark no yes (inverter) yes no
declaration of conformity no yes (inverter) yes no
declaration of incorporation no no no no
When handling lubricants, the protection regulations for people and the environment according to the
corresponding safety data sheets according to DIN 52 900 must be observed.
Ensure that the gear units are disposed of properly.
The best way to avoid waste is to recycle it:
- Sort metallic components correctly and recycle them.
- Sort the electronic components correctly and recycle them.
- Properly dispose of materials that are not suitable for recycling.
12. Notes on proper disposal