Sumitomo Cyclo Helical Buddybox User Manual

16 Operation & Maintenance Manual
Cyclo® HBB
Cyclo® HBB
3
Position the torque arm so it will be in tension during unit operation.
4
Position Torque Arm as close as possible to 90° relative to the unit
output bore.
Sumitomo does not recommend the use of multiple Torque Arm
Assemblies to achieve greater overall length.
5
After inserting the torque rod into the mounting surface, carefully tighten nuts on
either side of torque rod.
Do Not over tighten nuts. Tighten to point where rubber bushings can still
be hand rotated when the unit is turned off.
Before starting unit, verify that:
•Thetorquearmwillbeintensionwhentheunitisoperating.
•ThetorquearmisalignedwiththeCyclo®HBBhousingwhenviewed
from the side.
•Thetorquearmisperpendiculartothelinebetweentheaxisofthe
output shaft and the torque arm’s housing connection point.
•Thetorquearmisnottouchingthegearhousing.
Torque Arm Installation
Clevis Torque Arm Installation Procedure
CW Shaft
Rotation
CCW Shaft
Rotation
CCW Shaft
Rotation
CW Shaft
Rotation
Customer Mounting
Surface

Sumitomo Cyclo Helical Buddybox Specifications

General

Brand	Sumitomo
Model	Cyclo Helical Buddybox
Category	Engine
Language	English