5-22 Sun StorEdge 3000 Family FRU Installation Guide • May 2004
c. Type in the value 0 (to automatically read the chassis serial number from the
midplane) and press Return.
The value 0 is immediately replaced with the hex value of the chassis serial
number.
d. To implement the revised parameter value, choose “system Functions” on the
Main Menu, choose “Reset Controller” and press Return. Confirm Yes when
prompted.
15. On the firmware main menu, choose “view system Information,” and record the
serial number of the array. You will use this number later.
16. If you plan to use Sun StorEdge Configuration Service to manage and monitor the
RAID array, perform the following additional steps.
a. Restart the Sun StorEdge Configuration Service agent and the console.
b. From the Sun StorEdge Configuration Service main window in the console,
click View → Agent Options Management, and uncheck the box labeled Enable
JBOD support.
You need to disable the JBOD support temporarily in order to remove the old
JBOD drive assignments.
Serial Number
To Next Page
Loading...
Need help?
General
