Chapter 2 System Setup 25
Caution – The system is heavy. Two persons are required to move the system.
2. Lift the server (one person on each side of the server) and approach the rack with
the back of the server facing the front of the rack enclosure.
3. Align the crimped ends of the innermost glides on the server with the slide
bracket assemblies in the rack enclosure.
4. Holding the server level, slide it evenly into the rack enclosure until the
innermost glides stop in the slides.
The innermost glides are factory installed on the sides of the server enclosure.
!
Innermost glide
To Next Page
Loading...
Need help?
General
