Chapter 5 Replacing Field-Replaceable Units 5-17
■ If the fault is a host-detected fault (displays a UUID), continue to Step 8. For
example:
■ If the fault resulted in the FRU being disabled, such as the following,
then run the enablecomponent command to enable the FRU:
8. Perform the following steps to verify the repair:
a. Set the virtual keyswitch to diag so that POST will run in Service mode.
sc> showfaults -v
ID Time FRU Fault
0 SEP 09 11:09:26 MB/CMP0/CH0/R0/D0 Host detected fault
MSGID:
SUN4V-8000-DX UUID: f92e9fbe-735e-c218-cf87-9e1720a28004
sc> showfaults -v
ID Time FRU Fault
1 OCT 13 12:47:27 MB/CMP0/CH0/R0/D0 MB/CMP0/CH0/R0/D0
deemed faulty and disabled
sc> enablecomponent MB/CMP0/CH0/R0/D0
sc> setkeyswitch diag
To Next Page
Loading...
