5-14 Sun Fire T1000 Server Service Manual • January 2007
5.5 Replacing DIMMs
5.5.1 Removing DIMMs
Note – Not all DIMMs detected as faulty and offlined by POST must be replaced. In
service (maximum) mode, POST detects memory devices with errors that might be
corrected with Solaris PSH. See Section 3.4.5, “Correctable Errors Detected by POST”
on page 3-35.
Caution – This procedure requires that you handle components that are sensitive to
static discharges that can cause the component to fail. To avoid this problem, follow
the antistatic practices as described in Chapter 4.
1. Perform the procedures described in Chapter 4.
2. Locate the DIMM that you want to remove.
Use
FIGURE 5-11 and TABLE 5-1 to identify the DIMM that you want to remove.
To Next Page
Loading...
