Sun Microsystems Sun Fire X4150 - Resetting Passwords and Clearing CMOS NVRAM

82 Sun Fire X4150, X4250 and X4450 Servers Windows Operating System Installation Guide • January 2009
■ For the Sun StorageTek RAID controller, use the following:
8. Modify the txtsetup.oem file.
a. In a text editor, open the D:\RemoteInstall\Setup\English\Images\
image_dir\$oem$\textmode\txtsetup.oem file.
Where
image_dir is the directory on the RIS server that contains the RIS image.
b. Save and exit the file.
9. Start and stop the Remote Installation Service (BINLSVC) on the RIS server by
typing the following at a command prompt:
net Stop binlsvc
net Start binlsvc
10. Install the image onto your Sun Fire server.
Installing the RIS Image on a Client
System
This procedure describes how to install the RIS image that you created and modified
to a Sun Fire server. Before you perform this procedure, you must configure the RIS
image as described in “Add Drivers to a RIS Image” on page 72.
> Copy cdrom_drive:\drivers\windows\RAID\StorageTEK\2003\amd64\*
D:\remoteinstall\setup\english\images\image_dir\$oem$\textmode
> Copy cdrom_drive:\drivers\windows\chipset\* D:\remoteinstall\
setup\english\images\image_dir\$oem$\$1\drivers\chipset
> Copy cdrom_drive:\drivers\windows\IntelNIC\PRO1000\Winx64\*
D:\remoteinstall\setup\english\images\image_dir\$oem$\$1\drivers\
nic
> Copy cdrom_drive:\drivers\windows\TPM\2003_64\TPM_Driver\*
D:\remoteinstall\setup\english\images\image_dir\$oem$\$1\drivers\
tpm
> Copy cdrom_drive:drivers\windows\Display\2003_64\*
D:\remoteinstall\setup\english\images\image_dir\$oem$\$1\drivers\
video