Sundance Spas Maxxus - Programming the Time and Date

Page 63
880 SERIES
C. Service Lock (Figure 12.8b):
1. Tap to lock the spa. When this feature is activated all the lock
buttons are highlighted.
2. Tap (block) to select a number. Use or to select a
number from 0-9. Then move on to the next number until a four-digit
code has been selected.
3. Tap to activate the locking feature.
4. All spa functions are locked to allow for a temporary service mode
such as lter cleaning.
Note: This mode has a time out of 2 hours. The spa should not be left
in this lock mode for an extended period. Especially in colder climate or
when freezing conditions exist.
D. To Unlock (Figure 12.8c):
1. Enter the Lock menu. The type of lock that is
active will already be highlighted.
2. Tap (the rst block) to start entering
the code. Then move on to the next number
until the four-digit unlock code has been
entered.
3. Tap to unlock.
4. Tap to return to the “Setting” Menu.
12.9 Programming the Time and Date
From the Settings Menu, tap or to highlight the “Time & Date”
menu tab. Tap
Time & Date
to enter the programming options, Figures
12.9a and 12.9b.
A. To set the time:
The default time setting is a 12-Hour conguration. To choose the
24-Hour conguration, then tap
Time
to change the setting.
1. When you enter the menu, a few of the icons
will be highlighted, Figure 12.9c.
2. Tap or to change the hour in 1-hour
increments. To switch from “AM” to “PM” you
must round a 12-Hour period.
3. Tap the minute block
8:00
to program.
4. Tap or to change the minutes.
5. Tap to conrm and save your changes.
Lock
A
A
Figure 12.8c
SETTINGS
Time & Date
Language
Lock
Time & Date
8:00
Time Date
A
A
A
A
PM
Figure 12.9a
Figure 12.9b
Figure 12.9c
Time & Date
8:00
Time Date
A
A
PM