Sundance Spas Maxxus - 16 Troubleshooting - Procedures

Page 82
880 SERIES
16.0 Troubleshooting - Procedures
In the unlikely event your hot tub is not working the way you believe it
should, please rst review all the installation and operating instructions in
this manual and check the message on the panel display; second, if you
are still not satised it is working properly, please follow the appropriate
troubleshooting instructions.
PROBLEM PROCEDURE
None of the
components
operate (i.e.
pump, blower,
light)
Check the control panel lights.
1. If there are letters or symbols displayed on
the screen, refer to the previous section to
determine meaning and action required.
2. If nothing appears on the screen:
A. Check the household circuit breaker.
B. Contact you Sundance Spas dealer or
qualied service technician.
Pump does not
operate and icon
does
Depress JETS Button.
1. If no sound is detected or if a buzzing sound
is detected, turn off power to the spa and
contact your authorized dealer or qualied
service technician.
2. If motor operates, but now water ows to
jets:
A. Pump may not be properly primed. See
instructions below.
B. Contact your Sundance Spas dealer or
qualied service technician.
Pump Priming Instructions:
This method must be used for the jets pumps because these pumps
are not connected to the main lter system in any way.
1. Turn off the power to the spa.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector’s cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap nger tight, replace the handle, and turn the spa’s
power back on.
CAUTION: If freezing conditions exist and pump is not operational,
take measures to protect the system from freeze damage. See Section
titled “Winterizing,” page 72.