Sundance Spas Maxxus - Hot Tub Maintenance; Cleaning;Replacing the Filter Cartridge; Winterizing

Page 66
880 SERIES
13.0 Hot Tub Maintenance
Proper and regular maintenance of your hot tub will help it retain its
beauty and performance. Your authorized Sundance Spas dealer can
supply you with all the information, supplies, and accessory products you
will need to accomplish this.
!
DANGER: RISK OF SEVERE INJURY OR DROWNING
BY ENTRAPMENT!
• Keep hair, loose articles of clothing or hanging jewelry away
from suction ttings, rotating jets or other moving components to
avoid entrapment that could lead to drowning or severe injury.
• Never use the spa unless all suction guards, lter, lter lid, or
skimmer assembly are installed to prevent body and/or hair
entrapment.
• Never operate or use the spa if the lter, lter lid, or skimmer
assembly are broken or any part of the skimmer assembly is
missing. Please contact your dealer or nearest service center for
service.
• The suction ttings and suction covers in this spa are sized
to match the specic water ow created by the pump(s). If it
is necessary to replace the suction ttings, suction covers or
pump(s), be sure that the ow rates are compatible and are in
compliance with the VGB Safety Act, page 2.
• Never replace a suction tting or suction cover with one rated
less than the ow rate marked on the original suction tting.
Using improper suction ttings or suction covers can create
a body or hair suction entrapment hazard that may lead to
drowning or severe injury.
• Owners must alert all spa users to the potential risk of Hair,
Limb, Body, Evisceration (disembowelment), and Mechanical
Entrapment, page 6.
13.1 Cleaning/Replacing the Filter Cartridge
A reminder message appears on the control panel
display, after a specied number of days, to remind
you to clean the MicroClean Ultra lters. This
reminder must be reset at each interval. Refer
to Section 12.6, for additional information and
programming details.
Your Sundance hot tub is equipped with a two-stage MicroClean® Ultra
lter cartridge assembly under the lter lid (Sections 9.1-9.19 pages
22-40). Debris is ltered by the lter/circulation pump drawing
water through the lter assembly 8 hours a day, 7 days a week (unless
programmed otherwise). To ensure optimum performance, clean the
outer pleated lter and center insert monthly. Then replace the center
insert every 6 months, or as needed thereafter.
Filter 1 Replacement
Reminder
It’s time to clean or replace
your MicroClean Outer filters.
Contact your authorized dealer
if new filters are needed.
SnoozeReset
Filter 2 Replacement
Reminder
It’s time to replace your
MicroClean Inner filter.
Contact your authorized dealer
for a new filter.
SnoozeReset