Page 67
880 SERIES
All models include a suction cover lter (#6540-213) located
directly under the MicroClean® Ultra lter cartridge assembly
that prevents debris from entering the hot tub plumbing when
jets pump 1 is running. This lter should be cleaned every 2
months.
TO DECREASE RISK OF DEATH, DROWNING, OR ENTRAPMENT,
ALWAYS TURN POWER TO THE HOT TUB OFF BEFORE REMOVING
THE MICROCLEAN ULTRA FILTER ASSEMBLY!
Filter Cleaning/Replacement Procedure:
1
DANGER: TURN POWER TO SPA OFF! TO DECREASE
RISK OF DEATH, DROWNING, OR ENTRAPMENT,
NEVER OPERATE SPA WHEN FILTER IS NOT
PROPERLY INSTALLED OR IF WEIR ASSEMBLY IS
DAMAGED OR ALTERED!
2
Filter Cleaning Requirements:
• Clean MicroClean Ultra Pleated
Filter (1) monthly and replace every
18 months (6473-165).
• Rinse off MicroClean Ultra Insert (2)
monthly and replace every 6 months
or as needed (6473-164).
Filter Removal Instructions:
Loosen lter nut to provide clearance,
then remove MICROCLEAN Ultra Filter
Assembly from spa.
3
Monthly Filter Cleaning Procedure
We recommend cleaning the outer pleated lter (1) with a high
pressure water nozzle and the lter insert (2) with a low-pressure
water nozzle monthly. Periodically, the outer pleated lter cartridge
(1) will require a more thorough cleaning to remove embedded oils
and minerals by using special spa lter cleaners offered by your spa
dealer. Always remove the center lter insert (2) before cleaning the
outer lter (1) with chemicals. Never use lter cleaners of any kind
on the lter insert (2) or it may be damaged, come apart or allow
impurities to re-enter the water, increasing the risk of contracting
a waterborne illness (e.g. an infection, bacteria or virus) and/or
respiratory ailments.
!
!
Filter Nut
1
2
To Next Page
Loading...
