EasyManua.ls Logo

Sundance Spas Maxxus - Page 86

Sundance Spas Maxxus
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 80
880 SERIES
8. Frozen on Start-up: Flow switch is non-functional. Shorted ow
switch on system start-up (system disabled) and freeze condition
detected. Contact your authorized dealer or service organization.
9. Cool Warning: Spa water is more than 20°F/-6.67°C cooler than
the temperature set point, the circulation pump and heater will
automatically activate to provide freeze protection. The spa will stay
in this mode until the water temperature reaches 15°F/-9.44°C below
the set temperature. No corrective action is necessary.
Note: The heater icon will be blinking and the error icon will be
displayed under the temperature.
10. Freeze protection: A potential freeze condition has been detected. No
action is required. Jets pump(s) operate until the spa is out of danger.
No corrective action is necessary. If condition persists, contact your
authorized dealer or service organization.
11. Overheat protection: DO NOT ENTER THE WATER! Water
temperature is above acceptable limits. Heater is deactivated.
Remove the spa cover to speed cooling. If condition persists, contact
your authorized dealer or service organization.
Note: The heater icon will be blinking and the error icon will be
displayed under the temperature.
12. Watchdog Protection:
DO NOT ENTER SPA! Water temperature is
above acceptable limits. Your spa is deactivated. Remove the spa
cover to speed cooling. If condition persists, contact your authorized
dealer or service organization.
Note: The heater icon will be blinking and the error icon will be
displayed under the temperature.
13. Watchdog Freeze Protection: Spa water is below 40°F/4.4°C. Jet
pumps operate until the spa is out of danger. Contact your authorized
dealer or service organization.
Note: The heater icon
will be blinking and the error icon will be
displayed under the temperature.
14. Controller Overheat Protection: Controller temperature has exceeded
acceptable limits. If condition persists, provide shade for equipment
side of spa. Contact your authorized dealer or service organization.
Note: The heater icon will be blinking and the error icon will be
displayed under the temperature.
WARNING: RISK OF HYPERTHERMIA (OVER-HEAT-
ING) CAUSING SEVERE INJURY, BURNS, OR WELTS.
!
WARNING: RISK OF HYPERTHERMIA (OVER-HEAT-
ING) CAUSING SEVERE INJURY, BURNS, OR WELTS.
!

Table of Contents

Other manuals for Sundance Spas Maxxus

Related product manuals