SunFounder PiCrawler Kit
Note: Hello, welcome to the SunFounder Raspberry Pi & Arduino & ESP32 Enthusiasts Community on Facebook!
Dive deeper into Raspberry Pi, Arduino, and ESP32 with fellow enthusiasts.
Why Join?
• Expert Support: Solve post-sale issues and technical challenges with help from our community and team.
• Learn & Share: Exchange tips and tutorials to enhance your skills.
• Exclusive Previews: Get early access to new product announcements and sneak peeks.
• Special Discounts: Enjoy exclusive discounts on our newest products.
• Festive Promotions and Giveaways: Take part in giveaways and holiday promotions.
Ready to explore and create with us? Click [] and join today!
3.1.7 7. Servo Adjust (Important)
The angle range of the servo is -90~90, but the angle set at the factory is random, maybe 0°, maybe 45°; if we assemble
it with such an angle directly, it will lead to a chaotic state after the robot runs the code, or worse, it will cause the servo
to block and burn out.
So here we need to set all the servo angles to 0° and then install them, so that the servo angle is in the middle, no matter
which direction to turn.
1. To ensure that the servo has been properly set to 0°, first insert the servo arm into the servo shaft and then gently
rotate the rocker arm to a different angle. This servo arm is just to allow you to clearly see that the servo is
rotating.
3.1. Quick Guide on Python 35
To Next Page
Loading...
