Questions? Call or Text +1-801-658-0015 • 7
e Micro Welder Experts
Chapter 2: Setup and Installation
Safety Precautions
• Carefully read the Sunstone Safety and Basics booklet that accompanied this welder prior to operation.
As the operator of this welder, you assume full responsibility for your safety and those around you.
• Carefully read the users guide that accompanied your weld head or hand piece.
• Before depressing the foot pedtal and triggering a weld, make sure nothing is obstructing the elec-
trodes other than the workpiece being welded.
• If maintenance or setup is required, put the welder in the “Weld O” state or turn the unit o before
making adjustments to the weld head or other connected devices.
Workspace Considerations
• Ensure the workspace around the power supply is adequate for welding operations.
• Ensure there is sucient clearance around the sides and rear of the power supply for cables to run
freely.
• Good ventilation is important to keep the power supply from overheating. Be sure to have proper air
ow in and around the power supply.
• Be sure to keep the work surface stable, level, free of vibration, and strong enough to support the power
supply.
• Ensure the power supply is suciently distant from the weld head and incoming power.
• Avoid placing the power supply near sources of high frequency electromagnetic radiation.
• Keep the work area clear of excessive dust, ammable materials, acids, corrosive gases, salt, and any
moisture. Keep a clean work space!
Voltage and Power Requirements
The Sunstone Pico DC welder can be used with either 110VAC or 220VAC input voltage. The voltage is auto-
matically detected by the welder so no voltage selection is required prior to connecting and powering up.
To Next Page
Loading...
