Page | 15
Environments where precipitation or humidity are above 95%
Areas where the air circulation is too low.
ALSO CONSIDER:
Installing the indoor unit, outdoor unit, power supply cable, transmission cable, and
remote control cable at least 1 metre away from any television or radio receiver. This
will prevent TV reception interference or radio noise. This will prevent radio signal
interference from external units that might interfere with the Wi-Fi or GSM
monitoring.
If children under 10 years old may approach the unit, take preventive measures so
that they cannot reach and touch the unit.
Install the indoor unit on the wall where the height from the floors is higher than
1600mm.
Before connecting all wires, please take the metal cover off removing the screws as
shown below:
4.3. Mounting the Inverter
Select installation locations that adequate to support the weight of the converter.
Install this inverter at eye-level to allow the LCD to be read anytime.
An appropriate ambient temperature is between -25 ~ 60°C to ensure optimal
operation.
Be sure to keep other objects and surfaces as shown in the figure to guarantee
sufficient heat dissipation and have enough space to remove wires.
For proper air circulation to dissipate heat, allow a clearance of approximately 50cm
to the side.
To Next Page
Loading...
Need help?
General