Page | 36
5.9. Factory Reset and Lock Code
To set time, click on the BASIC icon and then on ‘Reset’.
Factory Reset: Reset all parameters of the inverter
Lock out all changes: Enable this menu to set parameters that before the unit is
locked and cannot be reset.
*Before performing a successful ‘Factory Reset’ and locking the systems the user must
enter a password to allow the setting to take place. The password for ‘Factory Reset’
is 9999 and for lock out is 7777.
How to change the name:
Change the letters in each box by
moving the arrows up and down and
then select OK. This will change the
name on the home screen.
How set the auto dim:
Set a number in the auto dim box to
dim the LCD after a number of
seconds.
How to turn the beep on or off:
Mark or unmark the beep box and the
press OK to configure it as you
prefer.
What this page displays:
Reset status.
Whether the ‘lock code’ is used or not.
What you can do from this page:
Reset the inverter to the factory
settings.
System diagnostics.
Change or set the ‘lock code’.