Release : 1.1f 115 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
3.77 show interfaces
This command displays the interface status and configuration.
show interfaces [{ [<interface-type> <interface-id>] [{ description |
stormcontrol | flowcontrol | status }] | vlan <vlan-id(1-4069)> | port-
channel <port-channel-id (1-65535)>}]
Syntax Description
interface-type - Can be gigabit Ethernet (gi) or extreme Ethernet (ex)
or qx-ethernet (qx)
interface-id - Physical interface ID including slot and port number
description - Description about the interface
storm-control - Broadcast, multicast, and unicast storm control suppression levels for an
interface
flowcontrol - Receive or send flow control value for an interface
status - Status of the interface
vlan - VLAN Identifier
port-channel - Port Channel Identifier
Mode
Privileged EXEC Mode
Example
SMIS# show interfaces gigabitethernet 0/2
Gi0/2 up, line protocol is up (connected)
Hardware Address is 00:01:02:03:04:22
RARP Client is enabled
MTU 1500 bytes, Full duplex, 100 Mbps, Auto-Negotiation
Input flow-control is off, output flow-control is off
Link Up/Down Trap is enabled
Reception Counters
Octets : 739284
Unicast Packets : 0
Non Unicast Packets : 5963
Discarded Packets : 0
Error Packets : 0
To Next Page
Loading...
