Supermicro SSE-G24-TG4 - Ip Rip Default Route Install

Release : 1.1f 636 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
25.14 ip rip default route install
This command installs the default route received in updates to the RIP database. The no form of
the command does not install default route received in updates to the rip database.
ip rip default route install
no ip rip default route install
Mode
Interface Configuration Mode
Defaults
no ip rip default route install
Example
SMIS(config-if)# ip rip default route install
RIP must be enabled on the interface on which this command is executed.
Related Command
show ip protocols - Displays information about the active routing protocol process