Release : 1.1f 575 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
23.3 set ip pim spt-switchperiod
This command configures the period (in seconds) over which the data rate is to be monitored for
switching to shortest path tree.
set ip pim spt-switchperiod <0-2147483647(in secs)>
Mode
Global Configuration Mode
Defaults
0
Example
iss (config)# set ip pim spt-switchperiod 60
The same period is used for monitoring the data rate for both source and group. To
switch to SPT, this period must be configured.
The SPT is used for multicast transmission of packets with the shortest path from
sender to recipients.
Related Command
show ipv6 pim thresholds – Displays threshold configured for SPT, RP thresholds, rate
limit values for both SM and DM
To Next Page
Loading...
