Release : 1.1f 746 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
27.38 clear ip bgp
This command resets the bgp connection dynamically for inbound and outbound route policy.
clear ip bgp {* | <ip-address>} [soft {in|out}]
Syntax Description
* - All BGP peers
ip-address - Remote IP address associated with specific BGP peer
soft - Soft clear
in - Initiates inbound soft reconfiguration
out - Initiates outbound soft configuration
Mode
Privileged EXEC Mode
Example
SMIS# clear ip bgp
If the keyword soft and the associated direction are not specified, then this causes hard clear i.e.
the BGP session with peer is reset.
Related Command
show ip bgp – Displays the BGP related information
To Next Page
Loading...
