Supermicro SSE-G24-TG4 - Switchport Map Protocols-Group

Release : 1.1f 360 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
15.22 switchport map protocols-group
This command maps the protocol group configured to a particular VLAN identifier for the specified
interface. The no form of the command un-maps the VLAN identifier to group Id mapping.
switchport map protocols-group <Group id> vlan <vlan-id(1-4069)>
no switchport map protocols-group <Group id>
Syntax Description
Group id - Group ID
Vlan - VLAN ID
Mode
Interface Configuration Mode
Example
SMIS(config-if)# switchport map protocols-group 1 vlan 2
Protocol group must have been configured.
Related Commands
map protocol - Adds a protocol to a protocol group for protocol based VLAN learning
show protocol-vlan - Displays the entries in protocol-VLAN database
show vlan protocols-group - Displays the protocol group database