Release : 1.1f 949 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
34.2 loop-protect - interface
This command enables the loop protection feature on the port interface. The no form of this
command disables the loop protection feature on the port interface.
To use the loop protection feature on any ports, this feature need to be enabled globally also on
the switch. To enable the loop protection feature globally, refer the section loop protect.
Loop protection feature is disabled by default on all ports.
loop-protect
no loop-protect
Mode
Interface Configuration Mode
Defaults
disable
Example
SMIS(config-if)# loop-protect enable
Related Commands
show loop-protect – Displays the loop protection feature status.
To Next Page
Loading...
