Release : 1.1f 938 / 985
Super Micro Intelligent Switch Command Line Interface User Guide
33.19 mac access-group
This command applies a MAC access control list (ACL) to a Layer 2 interface. The no form of this
command can be used to remove the MAC ACLs from the interface.
mac access-group <access-list-number (1-32768)> {in | out}
no mac access-group [<access-list-number (1-32768)>] {in | out}
Syntax Description
access-list-number - Access List Number
in - Inbound packets
out - Outbound packets
Mode
Interface Configuration Mode
Example
SMIS(config-if)# mac access-group 5 in
MAC access list must have been created.
Related Commands
mac access-list extended - Creates Layer 2 MAC ACLs, and returns the MAC-Access list
configuration mode to the user
show access-lists - Displays the access list statistics
To Next Page
Loading...
