rev. 08.15.2006.
1-1
Read This First!
TO UNPACK AND SET UP YOUR SURE TORQUE BENCHTOP TORQUE TESTER, PLEASE PERFORM THE
FOLLOWING STEPS:
Tools needed: Screwdriver, Allen wrench set.
1. Carefully remove the crating box cover to expose the machine, which is mounted on the crate’s base. Then using an
Allen wrench set, unscrew four screws in the machine’s base.
2. Next,
unscrew the screws holding the machine tight in the crating box then identify the other components and
assembly hardware.
3. Connect the main air supply to the rear air plug (refer to section 2.5.1 in the manual for specifications).
4. Attach the provided CE marked power supply to the rear of the system.
5. Run unit in manual cycle first to check component operation and alignment before running automatic cycle.
To Next Page
Need help?
General