rev. 08.15.2006.
1-5
Safety Comes First With ST
Throughout this manual, ST will emphasize safety precautions that should be adhered to by all personnel setting
up, operating, maintaining and repairing all ST equipment. Machine and personal safety depends on adherence to ALL
CAUTIONS and WARNINGS. Since actual working environments vary greatly, it is impossible to mention ALL
precautions that should be taken in any particular situation. It is your responsibility to be alert while working with any
machinery. Failure to do so will cause personal injury or equipment damage.
All precautions and warnings should be discussed with All personnel operating, working on, or near any packaging
equipment or production lines.
Follow All Safety Precautions In This Manual
NOTE:
Generally, CAUTION conditions refer to equipment damage, whereas WARNING conditions alert personnel to the
possibility of bodily injury. One hazardous condition, however, could easily cause the other.
WARNING
Personal Injury Or Equipment Damage May Result If The
Following 10 Safety Precautions Are Not Observed At All Times.
1. DO NOT operate any machine until you have completely read the manual.
2. DO NOT operate machine without safety guards in place. Stop the machine if guards are opened.
3. STAY CLEAR of all moving parts, AND NEVER wear baggy clothes around machines. Protect long hair with a
hair net.
4. STOP the machine before clearing container jams.
5. STOP the machine before cleaning.
6. STOP the machine before performing maintenance or lubrication procedures.
7. Disconnect power BEFORE changeovers or adjustments.
8. ENSURE machine is properly grounded.
9. Permit ONLY qualified personnel to open the electrical enclosure.
10. Ensure that All personnel are clear of the machine BEFORE starting.
REMEMBER!
ADHERE TO ALL SAFETY PRECAUTIONS LISTED ABOVE
AND THROUGHOUT THIS MANUAL
SURE TORQUE Worldwide Torque Testing Equipment Specialists!
To Next Page
Loading...