rev. 08.15.2006.
2-15
2. Installation Instructions
The following paragraphs explain the required information and procedures to properly install your ST-LAB Sure
Torque Electronic Torque Tester.
CAUTION
Read this section completely before installing your new unit.
2.1. Receiving the Unit
Your ST-LAB Sure Torque System is shipped with the mechanical component already assembled. It has to be
hooked up with the electronic control unit, the air supply and the optional printer and/or computer.
2.1.1. Inspecting
Sure Torque urges you to give your machine a complete inspection as soon as it is received. Any machine
damage and/or missing parts should be reported to Sure Torque immediately.
CONTACT:
SURE TORQUE
2532-34 Trailmate Drive
Sarasota, Florida 34243
Phone: (941) 753-1095 Fax: (941) 756-8425
IMPORTANT
Please Follow These Simple Inspection Steps:
1. Check the packing list that accompanies the equipment to ensure that ALL loose parts have been included.
2. Check the unit completely for possible shipping damage.
3. Check the unit completely for any screws, bolts, belts, wheels, or other parts that may have loosened
during shipment. These parts should be tightened and/or properly adjusted before operating the equipment.
4. Assemble the unit according to the following Unpacking instructions.
2.1.2. Unpacking
Remove all packing, shipping wire, and/or other materials that might interfere with machine operation or safety
and proceed with the following unpacking and set-up procedures.
IMPORTANT
To unpack and set up your new Sure Torque
Electronic Torque Tester, follow the steps below:
NOTE:
Tools needed: Screwdriver, Allen wrench set.
To Next Page
Loading...