SureShot IntelliShot - Loading Fill in Place Tanks; Fill in Place Tank Procedures and Reset

12
LOADING:FillinPlacetanks
ToFillorRefillTanksinPlace:
1. Openthefrontdoorofthedispenser.
2. Flipuptheaccessdooronthetopofthedispenserto
gainaccesstothetanklid.
3. Openthelidonthetanktobefilled.
4. FillorRefillthetanktoanydesiredlevelwithproduct
chilledto41°F/5°Corless.
5. Closetanklid.
6. Closethetopdoor.
7. Closethedispenserdoor.
8. Reset:seebelow
PortionControlFillinPlaceDispensers:RESETafterrefillingtanks
ToReset:
1. Selectthetankthathasbeenrefilledbypressing
the productselectionbuttonforthattank(e.g.
cream)onthebuttonpanel.
2. PresstheRESETbuttonnexttotheLCDDisplay.
ContinuetopresstheRESETbuttonuntiltheLCD
Displaymatchesthefilllevelonthetank(0.5gallon
increments).
NOTE:
· Theresetoperationmustbecompletedwithin3secondsofselectingtheproductbutton.
EverypressoftheRESETbuttonplacesthetimeoutfeaturebackto3seconds,allowing
timetocyclethroughtothecorrectlevelofrefill.Abeepisheardwitheachpressofthe
RESETbutton.Whentheselectedproductbutton’sLEDisextinguished,thenewrefill
levelisstoredinmemory.Bypressingthebuttonrepeatedly,therefilllevelwillcycle
throughtheallowable0.5gallonincrements.
· Lowtanklevelisindicatedb ytheslowflashingofthecorrespondingLEDonthebutton
panel. TheLEDwillbegintoslow flashwhenproductisatthe40oz(1200ml)levelofthe
tan k.Followtheproceduretorefillthetanktothedesiredlevel.Refillingandresettingthe
appropriatetankwillextinguishthelowlevellightindicator.
Thedispenserisnowreadytoresumeoperations.
ToRemoveanEmptyProductBagorTank:
1. Placeacontainerunderthedispensingvalvetocatchanyresidualproductandtoprevent
spills.
2. Openthevalvedoorbyunscrewingtheknobinacounterclockwisemotion.
3. Removetheemptybagortankwhilepinchingtheproductdeliverytubesothatitdoesnot
drip. Discardtheemptyproductbag.
4. Wash,rinse,sanitizeandairdrytheproducttank,usingcleaninginstructionsonpage22.
Reset