SureShot IntelliShot - Troubleshooting Dispenser Temperature; Adjusting for Dispenser Too Cold or Too Warm

26
Followtheinstructionsbelowforadjustments,dependingonwhetheryourdispenserisrunning
toocoldortoowarm.
IfTheDispenserIsRunningTooCold:
B16CircuitBoards C01008CircuitBoards
To increase the temperature or to make it
warmer, turn the white center slo t left or
counterclockwise 1 hour to 11 o’clock. Allow
thisadjustmenttotakeeffectfor3hours.
If still not warm enough, adjust the
Temperature Adjust to 10 o’clock and repeat
the wait time. You can further adjust the
temperatureto9o’clock.Donotadjustfurther.
To increase the temperature or to make it
warmer,presstheDOWNbuttononcetorecall
the currentsetting,thenimmediatelypressthe
DOWN button a second time to adjust the
refrigeration setting warmer by one setting.
The circuit board display should indicate this
newsetting.Allowthisadjustmenttotakeeff ect
for3hours.
Ifstillnotwarmenough,repeatthisprocedure.
Do not place the refrigeration setting on 00
becausethisistheOFFposition.
If,aftertheseadjustmentsaremade,yourdispenserisstillrunningtoocold,pleasecontactthe
SureShot DispensingSystems®TechnicalAssistanceCenterat18887779990or
19028659602duringyour1yearwarrantyperiodoraqualifiedRefrigerationTechnicianafter
yourwarrantyperiodhasexpired.
IfTheDispenserIsRunningTooWarm:
B16CircuitBoards C01008CircuitBoards
To decrease the temperature or to make it
colde r, turn the white center slot right or
clockwise 1 hour to 1 o’clock. Allow this
adjustmenttotakeeffectfor3hours.
Ifstillnotcoldenough,adjusttheTemperature
Adjust to 2 o’clock and repeat the wait time.
You can further adjust the temperature to 3
o’clock.Donotadjustfurther.
To decrease the temperature or to make it
colde r, press the UP button once to recall the
current setting, then immediately press a
second time to adjust the refrigeration setting
colde rbyonesetting. Thecircuitboarddisplay
should indicate this new setting.  Allow this
adjustmenttotakeeffectfor3hours.
Ifstillnotcoldenough,repeatthisprocedure.
If,aftertheseadjustmentsaremade,yourdispenserisstillrunningtoowarm,pleasecontactthe
SureShot DispensingSystems®TechnicalAssistanceCenterat18887779990or
19028659602duringyour1yearwarrantyperiodoraqualifiedRefrigerationTechnicianafter
yourwarrantyperiodhasexpired.