ABS: 4E-73
Front Wheel Speed Sensor Rotor Removal and
Installation (AN400A/ZAK9)
B905H14506006
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• Do not hit the front wheel speed sensor
rotor when dismounting the front wheel.
Removal
1) Remove the front wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation (AN400A/
ZAK9)” in Section 2D (Page 2D-6).
2) Remove the front wheel speed sensor rotor (1).
CAUTION
!
When replacing the tire, make sure not to
damage the sensor rotor.
Installation
Refer to “Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)” (Page 4E-74).
Install the front wheel speed sensor rotor in the reverse
order of removal. Pay attention to the following points:
• Install the wheel speed sensor rotor as the letters
“50T” face outside.
Tightening torque
Front wheel speed sensor rotor bolt (a): 6 N·m (
0.6 kgf-m, 4.5 lbf-ft)
• Install the front wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation (AN400A/ZAK9)”
in Section 2D (Page 2D-3).
• Check the clearance between the front wheel speed
sensor and sensor rotor using the thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.36 – 1.62 mm (0.014 – 0.064 in)
Rear Wheel Speed Sensor Rotor Removal and
Installation (AN400A/ZAK9)
B905H14506007
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• Do not hit the rear wheel speed sensor
rotor when dismounting the rear wheel.
Removal
1) Remove the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation (AN400A/
ZAK9)” in Section 2D (Page 2D-6).
2) Remove the rear wheel speed sensor rotor (1).
CAUTION
!
When replacing the tire, make sure not to
damage the sensor rotor.
1
I905H1450058-01
50T
(a)
I905H1450059-02
(A), (B)
I905H1240005-02
1
I905H1450060-01
To Next Page
Loading...
