4E-22 ABS:
DTC (Diagnostic Trouble Code) Output
(AN400A/ZAK9)
B905H14504021
NOTE
• Even through the ABS is operating
correctly, a DTC is memorized in any of the
following conditions.
– If the motorcycle is put on its
centerstand, the engine is started and
only the rear wheel is rotated.
– Previous malfunctions were repaired,
but the DTCs were not deleted.
• After carrying out DTC deleting and ABS
operation check, explain to the customer
that the ABS is operating correctly. Refer
to “DTC (Diagnostic Trouble Code)
Deleting (AN400A/ZAK9)” (Page 4E-25).
Use of Mode Select Switch
NOTE
• Don’t disconnect couplers from ABS HU,
the battery cable from the battery, ABS HU
ground wire harness from the engine or
main fuse before confirming the
malfunction code (self-diagnostic trouble
code) stored in memory. Such
disconnection will erase the memorized
information in ABS HU memory.
• Be sure to read “Precautions for Electrical
Circuit Service” (Refer to “Precautions for
Electrical Circuit Service” in Section 00 in
related manual and “Precautions for ABS
(AN400A/ZAK9)” (Page 4E-1).) before
inspection and observe what is written
there.
Connect the special tool to the mode select coupler to
output the memorized DTCs on the ABS indicator light.
1) Turn the ignition switch OFF.
2) Remove the meter panel. Refer to “Meter Panel
Removal and Installation” in Section 9D in related
manual.
3) Connect the combination meter coupler.
4) Connect the special tool to the mode select coupler
(1) (O – B/W).
Special tool
(A): 09930–82710 (Mode select switch)
5) Switch the special tool to ON.
1
I905H1450021-01
(A)
I905H1450006-01
I718H1450040-02
To Next Page
Loading...
