Suzuki AN400 - Wheel Speed Sensor and Sensor Rotor Inspection (AN400 A;ZAK9)

4E-74 ABS:
Installation
Refer to “Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)” (Page 4E-74).
Install the rear wheel speed sensor rotor in the reverse
order of removal. Pay attention to the following points:
• Install the wheel speed sensor rotor as the letters
“72T” face outside.
Tightening torque
Rear wheel speed sensor rotor bolt (a): 6 N·m (
0.6 kgf-m, 4.5 lbf-ft)
• Install the rear wheel assembly. Refer to “Rear Wheel
Assembly Removal and Installation (AN400A/ZAK9)”
in Section 2D (Page 2D-6).
• Check the clearance between the rear wheel speed
sensor and sensor rotor using the thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.16 – 1.62 mm (0.006 – 0.064 in)
Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)
B905H14506008
Wheel Speed Sensor
1) Remove the wheel speed sensor. Refer to “Front
Wheel Speed Sensor Removal and Installation
(AN400A/ZAK9)” (Page 4E-71) and “Rear Wheel
Speed Sensor Removal and Installation (AN400A/
ZAK9)” (Page 4E-72).
2) Inspect the wheel speed sensor for damage.
Clean the sensor if any metal particle or foreign
material stuck on it.
3) After finishing the speed sensor inspection, install
the wheel speed sensor.
Wheel Speed Sensor Rotor
1) Raise the wheel off the ground and support the
motorcycle with a jack or wooden block.
CAUTION
!
Make sure that the motorcycle is supported
securely.
2) Check that no wheel speed sensor rotor teeth are
broken and that no foreign objects are caught in the
wheel speed sensor.
72T
(a)
(a)
I905H1450061-02
(A), (B)
I905H1240009-02
I905H1450062-01
I905H1450049-01