ABS: 4E-25
DTC (Diagnostic Trouble Code) Deleting
(AN400A/ZAK9)
B905H14504022
Use of Mode Select Switch
1) Remove the meter panel. Refer to “Meter Panel
Removal and Installation” in Section 9D in related
manual.
2) Connect the combination meter coupler.
3) Connect the special tool to the mode select coupler
(O – B/W) and output the DTCs.
Special tool
(A): 09930–82710 (Mode select switch)
4) While the DTCs are being output, set the special tool
to OFF.
CAUTION
!
The DTC deletion mode is started after the
switch is set to OFF.
5) In the DTC deletion mode, switch the ABS test
switch from OFF to ON three times, each time
leaving it at ON for more than 1 second.
NOTE
The DTC deletion can be made within 12.5
seconds after the switch is turned ON.
DTC Deleting Diagram
I905H1450023-01
(A)
I905H1450006-01
I718H1450050-01
I718H1450051-01
DTC indicated
DTC erasing enabled
ABS indicator
light
ON
OFF
Mode select switch
ON
OFF
1 sec. 0.4 sec. each
0.4 sec. each
Erasing completed
“Erasing completed”
signal indicated
Erasing
started
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
I718H1450052-02
To Next Page
Loading...
