4E-26 ABS:
6) After deleting the DTCs, repeat the code output
procedure and make sure that no DTCs remain (the
ABS indicator light no longer flashes).
NOTE
If any DTCs remain, perform the appropriate
procedures, then delete the codes. If DTCs
are left stored, confusion may occur and
unnecessary repairs may be made.
7) Disconnect the mode select switch and reinstall the
removed parts.
8) Afterwards, ride the motorcycle at more than 30 km/
h (18.6 mile/h) and quickly apply the brakes to check
that the ABS activates correctly.
Use of SDS
1) Remove the upper meter panel. Refer to “Upper
Meter Panel Removal and Installation” in Section 9D
in related manual.
2) After repairing the trouble, turn OFF the ignition
switch and turn ON again.
3) Set up the SDS tool. (Refer to the SDS operation
manual for further details.)
Special tool
: 09904–41010 (SUZUKI Diagnostic system
set)
: 99565–01010–020 (CD-ROM Ver.20)
4) Click the ABS button (1).
5) Click the “DTC inspection” button (2).
6) Check the DTC.
7) Click “Clear” (3) to delete history code (Past DTC).
I905H1450017-03
1
I905H1450084-02
2
I718H1450055-01
3
I718H1450056-01
To Next Page
Loading...
