ABS: 4E-75
ABS Control Unit/HU Removal and Installation
(AN400A/ZAK9)
B905H14506009
Removal
WARNING
!
When storing the brake fluid, seal the
container completely and keep away from
children.
CAUTION
!
• This brake system is filled with an ethylene
glycol-based DOT 4 brake fluid. Do not mix
different types of fluid such as silicone-
based or petroleum-based.
• Do not use any brake fluid taken from old,
used or unsealed containers. Never reuse
brake fluid left over from the last servicing
or stored for long periods.
• Handle brake fluid with care: the fluid
reacts chemically with paint, plastics,
rubber materials etc. and will damage then
severely.
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• The ABS control unit/HU cannot be
disassembled.
1) Turn the ignition switch OFF.
2) Remove the front leg shield. Refer to “Front Leg
Shield Removal and Installation” in Section 9D in
related manual.
3) Drain the brake fluid. Refer to “Brake Fluid
Replacement” in Section 4A in related manual.
4) Remove the brake hose union mounting bolt (1).
5) Remove the brake hose union mounting bolt (2).
6) Loosen the flare nuts (3) and disconnect the brake
pipes.
7) Disconnect the ABS control unit coupler (4).
1
I905H1450063-01
4
3
2
I905H1450064-02
3
I905H1450065-01
To Next Page
Loading...
