4E-76 ABS:
8) Remove the ABS control unit/HU assembly by
removing the holder mounting bolts.
9) Remove the ABS control unit/HU (5) from the holder
(6).
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
CAUTION
!
• Route the brake hoses and pipes correctly.
Refer to “Front Brake Hose Routing
Diagram (AN400A/ZAK9)” in Section 4A
(Page 4A-1) or “Rear Brake Hose Routing
Diagram (AN400A/ZAK9)” in Section 4A
(Page 4A-2).
• Make sure to hold the brake pipe when
tightening the flare nut, or it may be
misaligned.
• Tighten the brake pipe flare nuts to the specified
torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lbf-ft)
• Bleed air from the brake fluid circuit. Refer to “Air
Bleeding from Brake Fluid Circuit” in Section 4A in
related manual.
I905H1450066-01
I905H1450067-01
I905H1450068-01
6
5
I905H1450069-01
(a)
(a)
I905H1450070-01
To Next Page
Loading...
