Suzuki AN400 - Repair Instructions; ABS Control Unit Coupler Disconnect and Connect (AN400 A;ZAK9); Front Wheel Speed Sensor Removal and Installation (AN400 A;ZAK9)

ABS: 4E-71
Repair Instructions
ABS Control Unit Coupler Disconnect and
Connect (AN400A/ZAK9)
B905H14506003
Disconnect
1) Turn the ignition switch OFF.
2) Remove the meter panel. Refer to “Meter Panel
Removal and Installation” in Section 9D in related
manual.
3) Pull up the coupler lock (1) and disconnect the ABS
control unit coupler (2).
Connect
Connect the ABS control unit coupler in the reverse
order of disconnect.
Front Wheel Speed Sensor Removal and
Installation (AN400A/ZAK9)
B905H14506004
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• The wheel speed sensor cannot be
disassembled.
Removal
1) Turn the ignition switch OFF.
2) Remove the front leg shield. Refer to “Front Leg
Shield Removal and Installation” in Section 9D in
related manual.
3) Disconnect the front wheel speed sensor coupler (1).
4) Remove the front wheel speed sensor mounting
bolts.
5) Remove the front wheel speed sensor as shown in
the front wheel speed sensor routing diagram. Refer
to “Front Wheel Speed Sensor Routing Diagram
(AN400A/ZAK9)” (Page 4E-9).
Installation
Refer to “Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)” (Page 4E-74).
Install the front wheel speed sensor in the reverse order
of removal. Pay attention to the following points:
• Install the front wheel speed sensor as shown in the
front wheel speed sensor routing diagram. Refer to
“Front Wheel Speed Sensor Routing Diagram
(AN400A/ZAK9)” (Page 4E-9).
• Check the clearance between the front wheel speed
sensor and sensor rotor using the thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.36 – 1.62 mm (0.014 – 0.064 in)
1
2
I905H1450053-01
1
I905H1450054-01
I905H1450055-01
(A), (B)
I905H1240005-02