Suzuki AN400 - Front Wheel Speed Sensor Routing Diagram (AN400 A;ZAK9)

ABS: 4E-9
Front Wheel Speed Sensor Routing Diagram (AN400A/ZAK9)
B905H14502003
“C”
“B”
1
“F”
2
“A”
“B”
“E”
1
1
“D”
1
“G”
3
“H”
I905H1450071-02
1. Clamp “D”: Clamp the white taping point of sensor lead wire and the protector of brake hose.
2. Leg shield brace “E”: Clamp the white taping point of sensor lead wire and the brake hose sleeve.
3. Front wheel speed sensor “F”: Clamp the protector of sensor lead wire and the brake hose sleeve.
“A”: Pass the sensor lead wire inside of leg shield brace. “G”: Cut off the excess end of clamp.
“B”: Clamp the white taping point of sensor lead wire and the
brake hose.
“H”: Outside marking.
“C”: Pass the sensor lead wire between front fender and front
fork. Pass the sensor lead wire in front of the front fender
mounting bolt.