4E-42 ABS:
DTC “35” (C1635): ABS Motor Malfunction (AN400A/ZAK9)
B905H14504008
Wiring Diagram
Refer to “ABS Unit Diagram (AN400A/ZAK9)” (Page 4E-8).
Troubleshooting
NOTE
After repairing the trouble, clear the DTC using SDS tool. Refer to “DTC (Diagnostic Trouble Code)
Deleting (AN400A/ZAK9)” (Page 4E-25).
Possible Cause
• Faulty HU motor
• Faulty wiring, etc.
Step Action Yes No
1 1) Inspect if the pump motor makes turning noise by setting
the ignition switch to ON from OFF when the vehicle
stands still.
Does the pump motor make any turning noise?
• Faulty HU motor
• Replace the ABS
control unit/HU.
Go to Step 2.
2 1) Remove the upper meter panel. Refer to “Upper Meter
Panel Removal and Installation” in Section 9D in related
manual.
2) Inspect the ABS motor fuse (1).
CAUTION
!
If a fuse is blown, find the cause of the problem
and correct it before replacing the fuse.
ABS motor fuse
20 A
Is the ABS motor fuse OK?
Go to Step 3. Replace the ABS motor
fuse.
I905H1450039-01
1
I905H1450040-01
To Next Page
Loading...
