Suzuki AN400 - Abs; Precautions; Precautions for ABS (AN400 A;ZAK9); ABS Information (AN400 A;ZAK9)

ABS: 4E-1
Brake
ABS
Precautions
Precautions for ABS (AN400A/ZAK9)
B905H14500001
Refer to “Precautions for ABS (AN400A/ZAK9)” in
Section 00 (Page 00-1) and “Precautions for Electrical
Circuit Service” in Section 00 in related manual.
ABS Information (AN400A/ZAK9)
B905H14500002
WARNING
!
• Be sure to bleed air from the brake fluid
circuit when the brake is felt spongy or
when a brake relating part is replaced.
• Never ride the motorcycle before bleeding
the air.
• Be sure to route the brake hoses correctly.
• The ABS does not shorten the motorcycle’s braking
distance. When riding down slopes or on wet or
bumpy roads the braking distance is lengthened as
compared to a motorcycle without ABS. In addition,
braking distance increases more, when the road is
slippery.
• The ABS does not control slides which may occur
when braking while turning. As with a motorcycle that
does not have ABS, it is best not apply the brakes
while turning.
• The brake levers may move by themselves when they
are applied. This is not a malfunction.
• Only use the specified tires.
General Description
Wheel Speed Sensor Description (AN400A/ZAK9)
B905H14501001
Wheel speed sensor consists of wheel speed sensor (1) and sensor rotor (2).
Front
Rear
1
2
I905H1450001-01
1
2
I905H1450002-02