Suzuki AN400 - Page 121

Table of Contents 5- i
5
Section 5
CONTENTS
Transmission / Transaxle
Precautions ................................................. 5-*
Precautions.............................................................. 5-*
Precautions for Transmission/Transaxle................ 5-*
Automatic Transmission......................... 5A-1
Schematic and Routing Diagram........................ 5A-*
Drive Train System ..............................................5A-*
Diagnostic Information and Procedures............ 5A-*
Automatic Transmission Symptom Diagnosis......5A-*
Repair Instructions ..............................................5A-1
Outer Clutch Cover Cushion Construction ...........5A-*
Clutch In / Stall Speed Inspection ........................5A-*
V-belt Type Continuously Variable Automatic
Transmission Removal and Installation .............5A-*
Drive V-belt Inspection .........................................5A-*
Cooling Fan Filter Inspection ...............................5A-*
Inner Clutch Cover Bearing Inspection ................5A-*
Inner Clutch Cover Bering Removal and
Installation..........................................................5A-*
Movable Drive Face Component..........................5A-*
Movable Drive Face Disassembly and
Assembly ...........................................................5A-*
Movable Drive Face Parts Inspection ................. 5A-*
Oil Seal Removal and Installation ....................... 5A-*
Clutch Shoe / Movable Driven Face
Components...................................................... 5A-*
Clutch Shoe / Movable Driven Face
Disassembly and Assembly .............................. 5A-*
Clutch Shoe and Movable Driven Face Parts
Inspection.......................................................... 5A-*
Outer Clutch Cover Cushion Construction
(AN400/A/ZAK9) ...............................................5A-1
Belt Cooling Duct Hose Construction (AN400/
A/ZAK9).............................................................5A-2
Belt Cooling Duct Hose Removal and
Installation (AN400/A/ZAK9) .............................5A-3
Specifications.......................................................5A-3
Service Data........................................................ 5A-*
Service Data (AN400K9).....................................5A-3
Service Data (AN400A/ZAK9).............................5A-3
Tightening Torque Specifications........................5A-3
Special Tools and Equipment ............................. 5A-*
Recommended Service Material ......................... 5A-*
Special Tool ........................................................ 5A-*
NOTE
For the items with asterisk (*) in the “CONTENTS” below, refer to the same section of the service manual
mentioned in the “FOREWORD” of this manual.