5A-3 Automatic Transmission:
Belt Cooling Duct Hose Removal and
Installation (AN400/A/ZAK9)
B905H15106018
Removal
1) Remove the front frame cover. Refer to “Front Frame
Cover Removal and Installation” in Section 9D in
related manual.
2) Remove the left slide leg shield. Refer to “Side Leg
Shield Removal and Installation” in Section 9D in
related manual.
3) Remove the clamp (1).
4) Remove the belt cooling duct hose (3) by loosening
the clamp screw (2).
Installation
Install the belt cooling duct hose in the reverse order of
removal. Pay attention to the following point:
• Install the belt cooling duct hose properly. Refer to
“Belt Cooling Duct Hose Construction (AN400/A/
ZAK9)” (Page 5A-2).
• Tighten the belt cooling duct hose clamp screw.
Tightening torque
Belt cooling duct hose clamp screw: 1.5 N·m (
0.15 kgf-m, 1.0 lbf-ft)
Specifications
Service Data (AN400K9)
B905H15107003
Refer to “Service Data (AN400K9)” in Section 0C (Page 0C-1).
Service Data (AN400A/ZAK9)
B905H15107004
Refer to “Service Data (AN400A/ZAK9)” in Section 0C (Page 0C-2) and “Service Data (AN400K9)” in Section 0C
(Page 0C-1).
Tightening Torque Specifications
B905H15107005
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C in
related manual.
1
3
2
I905H1510002-02
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Belt cooling duct hose clamp screw 1.5 0.15 1.0 )(Page 5A-3)
To Next Page
Loading...
