2D-3 Wheels and Tires:
Front Wheel Assembly Removal and Installation
(AN400A/ZAK9)
B905H12406015
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• Do not hit the front wheel speed sensor
rotor when dismounting the front wheel.
Removal
1) Remove the front wheel speed sensor (1) by
removing the mounting bolts.
2) Remove the front wheel assembly (2). Refer to
“Front Wheel Assembly Removal and Installation” in
related manual.
3) Remove the front wheel speed sensor rotor if
necessary. Refer to “Front Wheel Speed Sensor
Rotor Removal and Installation (AN400A/ZAK9)” in
Section 4E (Page 4E-73).
Installation
Refer to “Front Wheel Related Parts Inspection” in
related manual.
Refer to “Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)” in Section 4E (Page 4E-74).
Install the front wheel assembly in the reverse order of
removal. Pay attention to the following points:
• Install the front wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation” in related
manual.
• Check the clearance between the front wheel speed
sensor and sensor rotor.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.36 – 1.62 mm (0.014 – 0.064 in)
1
I905H1240003-01
2
I905H1240004-01
(A), (B)
I905H1240005-02
To Next Page
Loading...
