Wheels and Tires: 2D-6
Rear Wheel Assembly Removal and Installation
(AN400A/ZAK9)
B905H12406018
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• Do not hit the front wheel speed sensor
rotor when dismounting the front wheel.
Removal
1) Remove the muffler (1) and rear wheel assembly (2).
Refer to “Rear Wheel Assembly Removal and
Installation” in related manual.
2) Remove the rear wheel speed sensor rotor if
necessary. Refer to “Rear Wheel Speed Sensor
Rotor Removal and Installation (AN400A/ZAK9)” in
Section 4E (Page 4E-73).
Installation
Refer to “Rear Wheel Related Parts Inspection” in
related manual.
Refer to “Wheel Speed Sensor and Sensor Rotor
Inspection (AN400A/ZAK9)” in Section 4E (Page 4E-74).
Install the rear wheel assembly in the reverse order of
removal. Pay attention to the following points:
• Install the rear wheel assembly and muffler. Refer to
“Rear Wheel Assembly Removal and Installation” in
related manual.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.16 – 1.62 mm (0.006 – 0.064 in)
1
2
I905H1240008-01
(A), (B)
I905H1240009-02
To Next Page
Loading...
